P/N 1126870 Rev. B
6
PROBLEM:
TRY THIS:
S
ystem will not run in
Express
Mode
1.
Check all encoder wires between motor and receiver for cuts. Make sure connec
-
tors are connected tightly. Make sure the black encoder wire is always connected to
another black encoder wire at connectors. On 4500 HD tarping systems, make sure
sealed weatherpack connectors are snap-locked together. There is one weatherpack
connector near the motor and one in the kingpin area.
2.
Call Shur-Co’s Help Line.
Troubleshooting Guide
- continued
NOTE:
To quickly determine if problem lies with wiring between battery and solenoid, disconnect power from truck and hook
jumper cables from vehicle directly to solenoid. Hook positive battery cable to solenoid positive post (marked
+
). Hook negative
battery cable to solenoid negative post (marked
-
). If system runs normally, problem is with wiring supplying power to solenoid.
Changes or modifications not expressly approved by party re
-
sponsible for compliance could void user’s authority to operate
equipment.
NOTE:
Equipment has been tested and found to comply with
limits for Class B digital devices, pursuant to part 15 of FCC
Rules. Limits are designed to provide reasonable protection
against harmful interference in residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
instructions, may cause harmful interference to radio
communications. However, there is no guarantee interference
will not occur in a particular installation. If equipment does
cause harmful interference to radio or television reception,
which can be determined by turning equipment off and on,
user is encouraged to try to correct interference by one or
more following measures:
- Reorient or relocate receiving antenna.
- Increase separation between equipment and receiver.
- Connect equipment into outlet on different circuit.
- Consult dealer or experienced radio/TV technician for help.
Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne peut pas provoquer d'interférences, et (2)
cet appareil doit accepter toute interférence, y compris celles
susceptibles de provoquer le fonctionnement du dispositif.
RADIO & TELEVISION INTERFERENCE
Summary of Contents for SMART3
Page 1: ...Wireless Remote P N 1126870 Rev B ...
Page 8: ......