Battery installation
1. Loosen the screw and open the battery compartment lid.
2. Insert 6x AA batteries (not included) in the battery case
with correct polarity.
3. Close the lid with the screw.
Parts
Instructions
Please read the instructions carefully before operation and keep it for further reference.
Wall climbing car (2x)
Controller/charger (2x)
USB charging cable (2x)
Small screwdriver (2x)
Charging your climbing car by Controller
1. Make sure the car is switched “OFF” before charging.
When the front/rear lights starts flashing, it means the battery is low
and needs to be recharged.
2. Switch “ON” the controller and connect the charging cable from the controller with the car. The charging indicating light
turns RED while charging and goes GREEN once charging is complete. If the indicating light flickers while charging, the
AA batteries are low power and please replace with new batteries. A full charge will take 30-60 minutes depending on
the remaining power of the battery in the controller.
3. Please switch “OFF” the controller when the charging is complete
and remove the charging cable from the car.
OFF
ON
OFF
ON
Summary of Contents for Crzy Driver 228-432
Page 1: ...RACINGTHEWALL The easy way to play WITH FUN 8 AGE ...
Page 22: ...Notizen note notes Aantekeningen ...
Page 23: ......
