8
Ordercode: 40297
Titan Strobe BLAZE
Control Modes
There are 3 modes:
•
Manual
•
Master/Slave
•
DMX-512/RDM (3CH, 5CH, 9CH)
One Titan Strobe (Manual)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Titan Strobe is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14-15 for more information about Manual mode.
Multiple Titan Strobes (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin/5-pin XLR cable to connect the Titan Strobe.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 14-15 (Manual
mode). This means that you can set your desired operation mode on the master device and all
slave devices will react the same as the master device.
Multiple Titan Strobes (Master/Slave control)
Fig. 03
