7
Ordercode: 30659
Sunstrip II Stageblinder
Installation
Remove all packing materials from the Sunstrip II Stageblinder. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Showtec Sunstrip II Stageblinder uses the GU4 (ordercode
) as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage
! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure:
01)
Disconnect the Sunstrip II Stageblinder from power before installing the lamp.
02)
Remove the lamp from the box and hold it
by the base
. Read lamp instructions.
Do not touch the
lamp bulb glass
. Oil on hands shortens the lamp’s lifespan. If you touch the bulb glass, wipe it off with
a clean, lint free towel and rubbing alcohol.
03)
Insert the lamps (Fig.02).
04)
The Sunstrip II Stageblinder is now ready to use.
Note:
The bulbs are connected in series; If one bulb fails, the other bulbs will fail as well.
Fig. 02
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
