SHOWTEC Sunstrip Active DMX, User Manual

Page: 11 / 17

9
Selecting DMX Address Mode
DMX mode is indicated by an “ A ” followed by 3 digits (001-512) in the LED Display.
Setting the DMX Address
Once you have activated the DMX Mode, you can push the UP or DOWN button
to change the setting from 001-512.
CHASE Mode
You can only use this mode when you are using the device as a Chaser. The unit has 16 built-in programs
except for Auto and Full. You can select any of these programs to create a chase for a lightshow.
You can also control the speed at which the programs will be chasing.
Selecting the Chase Mode
Chase mode is indicated by a “P” followed by 2 digits (01-16) in the LED Display.
“
P ” means Chase Mode and shows the Chase Mode has been activated.
If the Chase Mode has been activated, the Chase program Mode starts and
is the Default setting.
Setting the Chase Program
Once you have activated the Chase Mode, you can push the UP or DOWN button
to change the setting from 01-16. The Chase pattern is shown by a “
P ”
in the display and further by 01-16, AUTO or FULL.
You can select any of these settings to run at a single time.
Selecting the Chase Speed
To adjust the Chase Speed, you must activate the Chase Speed Mode.
Press the MENU Button until the display shows “
SP ” followed by 2 digits.
Setting the Chase Speed
In this Mode, you can adjust the Program Chase Speed. Use the UP or DOWN
button to change the setting from 01-99. A value of 01 means the slowest chase
speed of approximately once every 30 sec. A value of 99 means the fastest chase
speed of approximately 0.1 sec.