7
Ordercode: 30774
Stage Blinder 8 DMX
Backside
Fig. 02
04)
Power cable 240V AC, IN (G1-G2)
05)
Power cable 240V AC, IN (G3-G4)
06)
DIP switches (G1-G2)
07)
DIP switches (G3-G4)
08)
3-pin DMX signal connector OUT
09)
3-pin DMX signal connector IN
10)
4 x Fuse T10AL/250V
The Stage Blinder’s light output is divided into 4 sections: G1, G2, G3
and G4.
By flipping the DIP switches on the left control panel
(06)
you can
control sections G1 and G2.
By flipping the DIP switches on the right control panel
(07)
you can
control sections G3 and G4.
Fig. 03
Installation
Remove all packing materials from the Showtec Stage Blinder 8 DMX. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.