SHOWTEC Sky Spot 4000, User Manual

Page: 8 / 14

6
Installation
Installing the Lamp
The Showtec Sky Spot 4000 uses the XOB 4000W Xenon (ordercode 80918) bulb as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage ! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
XBO lamps are at high internal pressure when cold (up to 35 bar or approximately 525 psi) and at operating
temperature (up to 80 bar or approximately 1200 psi at bulb wall temperatures of 600°C to 800°C).
Therefore, XBO lamps may unexpectedly rupture resulting in the discharge of hot fragments of quartz
and/or glass and metal. In the event of such a rupture, there is a risk of personal injury, burns and fire. Only
handle lamps with their protective covers in place.
OSRAM XBO: These lamps use standard quartz glass and will also emit UV radiation that produces ozone.
These lamps, like the W/4 types, must always be externally ventilated. With these types of lamps, health
risks must always be minimized by suitably extracting the air from the lamp housing and externally venting
it.
Procedure :
• Always read the safety instructions that are included with the lamp.
• Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean,
lint-free towel and rubbing alcohol.).
• Always read all the safety warnings at the beginning of this manual, before replacing the lamp !!!
1. Remove the 4 screws 2. Remove the screw