SHOWTEC Showmaster 48 MKII, Manual

Page: 10 / 24

9
Ordercode: 50831
Showmaster 48 MKII
07) Press the Page button to select a page (Page 1-4) to store your scenes.
08) Press the Mode Select button to select CHASE SCENES.
09) Press and hold down the Record button and press the flash button
between 25-48. All LEDs will flash, indicating that the scenes have been
stored under that flash button/playback fader, providing that there was
more than one scene in the memory. A chase will be then created
automatically.
10) You can continue programming or exit. In order to exit programming,
press and hold down the Record button and press the Rec Exit button,
the Record LED should go off.
Example:
Program a 16-step chase with channel 1-16 at full in sequence into flash button 15 of Page 1.
01)
Enter the Recording mode.
02) Move the Master A & B faders to maximum position and Fade fader to the top position.
03) Tap the Mode Select button to select 1-48 Single mode.
04) Move the Channel fader 1 to the top position, its LED will light up at full intensity.
05) Tap the Record button to program this step in the memory.
06) Repeat steps 4 and 5 with the channel faders 2-16.
07) Press the Page button until “Page 1” LED lights up.
08) Press the Mode Select button to select CHASE SCENES.
09) Press and hold down the Record button and press the flash button 15. All LEDs will flash, indicating
that you have stored the scenes under flash button/playback fader 15. Because of the fact that
there were more scenes in the memory, the chase has been created.