SHOWTEC POWER SPOT 9 G6 TOUR V1, Manual

Page: 11 / 28

10
Ordercode: 42576
Power Spot 9 Q6 Tour
Installation
Remove all packing materials from the Power Spot 9 Q6 Tour. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be sound-controlled as it is equipped
with a built-in microphone.
Control Modes
There are 6 modes:
• Manual Mode (Static Color)
• Auto Mode
• Built-in programs
• Sound-controlled
• Master/Slave
• DMX-512 (6CH, 8CH, 10CH)
One Power Spot (Manual Mode, Auto Mode and Built-in programs)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Power Spot is not connected with a DMX cable, it functions as a stand-alone device.
04) Please see page 15-17 for more information about the Built-in programs, Auto Mode and Manual
Mode.
One Power Spot (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Power Spot will react to the beat of
the music.
04) Please see page 15 for more information about the sound-control options.
Multiple Power Spots (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Power Spot.
The pins: 01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15-17 (Built-in
programs, Auto Mode, Manual Mode or Sound-controlled Mode). This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.