12
Ordercode: 40207
Phantom 75 MKII LED Spot
The Phantom 75 MKII LED Spot can be operated with a controller in
control mode
or without the controller
in
stand-alone mode.
Control Panel
A) LCD display
B) MODE button
C) UP button
D) DOWN button
E) ENTER button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Phantom will respond to the controller.
Please note, when you use the controller, the unit has
14
channels.
When using multiple Phantoms, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Phantom should be
1(001)
; the DMX address of the second
Phantom should be
1+14=15 (015
); the DMX address of the third Phantom should be
15+14=29 (029)
, etc.
Please, be sure that you do not have any overlapping channels in order to control each Phantom
correctly. If two or more Phantoms are addressed similarly, they will work similarly.
Controlling:
After having addressed all Phantom fixtures, you may now start operating these via your lighting
controller.
Note:
After switching on, the Phantom will automatically detect whether DMX 512 data is received or
not.
If there is no data received at the DMX-input, the “
LED
“ on the control panel will not flash.
If not, the problem may be:
•
The XLR cable from the controller is not connected with the input of the Phantom 75 MKII LED Spot.
•
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
