SHOWTEC NanoQ 12 Q4 V1, Manual

Page: 8 / 28

Ordercode: 43710
NanoQ 12 Q4
Backside
Fig. 02
04) Mode button
05) Setup button
06) Up button
07) Down button
08) 5-pin DMX signal connector IN
09) 3-pin DMX signal connector IN
10) Pro power connector 100-240V IN
11) LCD display
12) 5-pin DMX signal connector OUT
13) 3-pin DMX signal connector OUT
14) Pro power connector 100-240V OUT
NOTE: Knowledge of DMX is required to fully utilize this unit.
Installation
Remove all packing materials from the NanoQ 12 Q4. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
7