SHOWTEC LED Powerbrick Set, Product Manual

Page: 8 / 17

7
FUNCTIONS:
There are 3 options to operate the LED Powerbrick: Stand-alone
Master / Slave
DMX Mode
After completing your settings, be sure to unplug the Powerbricks and the controller, otherwise errors could
occur.
This way you reset the entire system, but your settings keep stored in the memory of the controller.
Stand-alone
1. The device will start test-mode.
2. Press MODE button to enter mode setting.
3. Switch to System Mode, then press the Set Up-button.
4. Enter the amount of tubes you are using.
5. For Stand-alone you have to use DMX Channel: 0, then press the Set Up-button again.
6. The LCD now shows “Set Address YES”; press SETUP-Button (=NO) to keep your previous settings,
or YES (=Up-Button) to store your choice. The LED Tubes will light up.
7. Now your unit is a stand-alone. You will find all the pre-programmed scenes below.
Menu
1. Static RED
Function Set
2. Static GREEN Function Set
3. Static YELLOW Function Set
4. Static BLUE Function Set
5. Static PURPLE Function Set
6. Static CYAN Function Set
7. Static WHITE Function Set
8. Color Change Function Set
9. Flow 1 (FF) Function Set
10. Flow 2 (REW) Function Set
11. Flow 3 (FF/REW) Function Set
12. 2 Color Chase Function Set
13. Multi-Color Chase Function Set
14. Fade Change Function Set
15. 2 Color Fade Chase Function Set
16. Auto Run Function Set
17. System Mode Function Set
When “Function Set” appears in the LCD, then you are able to make some extra settings: Dimmer, Run
Speed, Flash Freq, etc.