10
Order code: 41166
Illumilift RGBW Turbo
Control Modes
There are 2 modes:
●
Manual
●
DMX-512 (6CH, 10CH)
One Illumilift (Manual)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Illumilift is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 14 for more information about Manual mode.
Multiple Illumilifts (DMX Control)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Use a 3-pin XLR cable to connect the Illumilifts and other devices.
04)
Link the units as shown in Fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third and fourth units.
05)
Supply electric power: Plug electric mains power cords into each unit's pro power socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Illumilifts DMX Setup
Fig. 04
Note : Link all cables before connecting electric power
