9
Order code: 41166
Illumilift RGBW Turbo
LED Sphere
Fig. 03
14)
Safety eye
15)
5-pin signal connector IN
Installation
Remove all packing materials from the Illumilift RGBW Turbo. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Power the device up ONLY when the LED sphere IS INSTALLED.
Power the device up ONLY when the controller is in VERTICAL position.
The built-in winch system resets itself upon each start-up. If the controller is not in vertical
position and/or the LED sphere is not installed, it may result in twisting of the cable that may
cause damage to the built-in winch system and the warranty will become void.
Before powering the Illumilift up, always make sure that:
●
the controller is positioned VERTICALLY.
●
the LED sphere is installed and secured by means of the safety eye.
●
the cable tie, keeping the hoisting cable in position, is removed.
●
the hoisting cable is not loose.
●
the maximum cable load (2 kg) is not exceeded.
●
the movement of the Illumilift is not interrupted in any way.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120 V specification product on 230 V power, or vice versa.
Connect the device to the main power supply.
