10
Stand-alone Mode
The fixtures on a data-link are not connected to the controller, but can execute pre-set programs, which can
be different for every fixture.
To set the program to be played, see the “Stand-alone setting “ ( menu ) Stand-alone operation” can
be applied to a single fixture (the fixture may be set to the master/slave mode or controller mode) or to
multiple fixture operating synchronously.
For synchronous operation of multiple fixtures the fixtures must all be connected on a data-link and one of
them is set as a master (master mode) and the rest as slaves (slave mode). The DMX address of all the
slaves are assigned to
and on that particular slave address only one fixture can be connected. To the
fixture as the master or slave, see “Addressing” (menu
).
If the master fixture resets or runs a test (program), all slaves will execute these acts too.
You can’t play or edit any program on a slave, if the master is switched on and connected to the
master/slave chain.
Note: Disconnect the fixtures from the DMX controller before master/slave operating, otherwise data
collisions can occur and the fixtures will not work properly!
It’s necessary to insert the XLR termination plug (with 120 Ohm ) into the input of the master fixture and into
the output of the last slave fixture in the data-link, in order to ensure proper transmission on the data link.
From the master’s control panel it is possible to control any slave in a master/slave chain.
Functions control panel
The control panel is situated on the front of the base and offers several features. You can simply set the
DMX address, master/slave mode, make a reset and also use many functions for setting purposes.
The main menu of the control panel is accessed by pressing the button [MODE] - press this one until the
display shows
(with actually stored address).
Browse the menu by pressing or buttons - the display will show :
Press if you wish to select one of them. The functions are described in the following sections and the
function hierarchy is shown below.
Summary of Contents for Fascinator 30918
Page 1: ...Fascinator ORDERCODE 30918 ...
Page 18: ...2005 Showtec ...