8
Multiple Fascinators
1.
Fasten the effect light onto firm trussing
. Leave at least 1 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Fascinators and other devices.
The pins:
1.
Earth
2.
Signal -
3.
3.
Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do not
supply power before the whole system is set up and connected properly.
5)
Press
,
until the display shows F6-n or F6-y (with actually stored address).
6)
Select
, the display shows
. Select
,
the display shows “
. Then select F4-y (audio-
controlled) on the master device. Only one fixture can be the master.
7)
On the slave devices you must select F6-n and F4-n. The DMX light on the slave devices will start
blinking. The slave devices must have address A001.
Multiple Fascinators Set Up
DMX-Set up
Master/Slave Set up
Fig. 4
Note : Link cables before connecting electric power
Summary of Contents for Fascinator 30918
Page 1: ...Fascinator ORDERCODE 30918 ...
Page 18: ...2005 Showtec ...
