15
Ordercode: 42197
LED Lightbar 12 Pixel
Master / slave addressing
Master
01)
The default setting for this device is master.
02)
Only one fixture can be the master.
Note:
•
Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions may occur and the fixtures will not work properly!
•
In master/slave mode, the master fixture can execute the built-in programs, all the slave fixtures will
work the same.
•
When operating the master/slave chain, you can identify the master fixture from the slave fixtures
easily. The master doesn’t have any cable plugged into the DMX input connector.
Slave control
This function allows you to control the slaves from the master’s control panel in a master/slave setup.
01)
Only 1 fixture can be the master, the others have to be Slaves. The Default setting for a device is
Master. So on the first device you don’t have to change anything.
On the slave devices you must press the
Mode
button until the display shows
.
02)
All slave devices must have address
.
Sound control Mode
With this menu you can set the sensitivity of the sound mode from the LED Lightbar 12 Pixel.
01)
Press the
Mode
button on the device, until the display shows
.
02)
Press the
Setup
button to enter the submenu.
03)
You can scroll through these options with the
Setup
button.
04)
You can choose between 3 sound modes
,
or
.
05)
With the mode
, the LED Lightbar will react to the beat of the music from the leftside to the
rightside of the bar.
06)
With the mode
, the LED Lightbar will react to the beat of the music from the rightside to the
leftside of the bar.
07)
Turn on the music and the
LED Lightbar 12 Pixel
will react to the beat of the music.
You can set the sensitivity from low -sensitivity to high-sensitivity
between SU.00 - SU.31 with the
Up
and
Down
buttons.
