23
Compact Par 7 Q4
Product code: 42582
Fail
Behavior of the device in case of DMX failure
(OFF/HOLD). If you select OFF, the device will black
out the light output if there is no DMX signal. If you
select HOLD, the device will use the last properly
received DMX signal.
Sync
Synchronization over DMX (ON/OFF). Enable this
option to activate the synchronization of the output
of the built-in chases across all devices connected
on one DMX link.
Reset
Reset the device to the default factory settings
(NO/YES). After reset the device will start up in auto
run mode.
02)
Press the SETUP button to enable configuration of the settings.
03)
Press the UP/DOWN buttons to select the setting.
Information
In this menu you can see the temperature of the LEDs and the firmware version.
01)
Press the UP/DOWN buttons to toggle between the following 2 options:
Temp
See 6.6.8.1. Temperature on page 23 for more information.
Version Firmware version of the device
02)
Press the SETUP button to view the parameter.
Temperature
In this submenu you can see the temperature of the LEDs. The display shows one of the following 2
indications:
The temperature of the LEDs is normal.
The temperature of the LEDs is too high.
Attention
Switch off the device, if the display shows that the temperature of the LEDs is too high.
