8
Installation
Remove all packing materials from the
Aircone LED 1W
. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.
Control Modes
FUNCTIONS:
There are 4 modes:
• Manual control
• Built-in Programs
• Sound-controlled
• DMX512 (1, 2, 3 or 7 Channels)
One Aircone LED 1W (Manual Control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Aircone LED 1W is not connected by a DMX-cable, it functions as a stand-alone device.
If
the device is set to , , or , then the fixture is manually
controlled.
Please see page 14 for more information about manual control Mode.
One Aircone LED 1W (
Built-in Programs, Auto Run
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Aircone LED 1W is not connected by a DMX-cable, it functions as a stand-alone device.
If
device is set to or , then the fixture will play one of its built-in programs.
Please
see page 14 for more information about the built-in programs.
One Aircone LED 1W (Sound-control)
1.
Plug the end of the electric mains power cord into a proper electric power supply socket.
2.
Turn on the music. If device is set to (Audio), then the fixture will react to the beat of the
music.
Multiple Aircone LED 1Ws (DMX Control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Aircone LED 1W and other devices
.
3.
Link the units as shown in (figure 2), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units
.
Summary of Contents for Aircone 1W LED
Page 13: ...12 Menu Overview...
Page 22: ......
