11
Order code: 34010
ACT Fresnel 20 WW
Control Modes
The ACT Fresnel 20 WW can be operated only manually.
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Secure the device with a safety cable (order code 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Turn the manual dimmer control (09) to adjust the intensity of the light.
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04)
The electric power supply cables must not show any damages or material fatigue.
The ACT Fresnel 20 WW requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light output will be significantly reduced. Disconnect the mains power supply and
then wipe the housing with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner
and a soft cloth. Do not use alcohol or solvents.
The front lens will require weekly cleaning, as smoke fluid tends to build up residues, reducing the light
output very quickly.
Replacing the Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below:
01)
Unplug the unit from electric power source.
02)
Insert a screwdriver into the slot of the fuse cover. Turn the fuse holder counterclockwise. The fuse
holder will come out.
03)
Remove the used fuse. If brown or unclear, it is burned out.
04)
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LED, the fuse.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02)
The LED. Return the device to your Showtec dealer.
03)
The fuse. Replace the fuse. See page 11 for replacing the fuse.
04)
If all of the above appears to be O.K., plug the unit in again.
05)
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
06)
Return the device to your Showtec dealer.
