9
Order code: 34010
ACT Fresnel 20 WW
Installation
Remove all packing materials from the ACT Fresnel 20 WW. Check if all foam and plastic padding is
removed. Connect the device to the main power supply.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120 V specification product on 230 V power, or vice versa.
Connect the device to the main power supply.
Beam Angle Adjustment
The beam angle of the ACT Fresnel 20 WW can be adjusted manually in the range 8°–55°. To adjust the
beam angle, follow the steps below:
01)
Turn the zoom control (05) counterclockwise to loosen it.
02)
Slide the zoom control (05) forwards or backwards to achieve the desired beam angle (see Fig. 06).
03)
After adjusting the beam angle, turn the zoom control (05) clockwise to tighten it. Do not
overtighten it.
Fig. 06
