11
51329
Galactic RGB850
13)
X-size control knob
14)
ILDA input
15)
ILDA through
16)
RGB + ILDA LED indicators
17)
3-pin DMX signal connector (OUT)
18)
Cooling fan
19)
3-pin DMX signal connector (IN)
20)
IEC Power connector AC 100-240V + Fuse T1,6A/250V
21)
Power switch ON/OFF
Installation
Remove all packing materials from the Galactic. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
The Interlock plug/remote plug and safety keys are included in the box.
The interlock is the “included-in-the-box” successor for the optional remote interlock (
).
They should be kept with the Galactic laser !!!
The following safety precautions should be followed:
●
The remote control plug should be placed on the backside (10) of your
Galactic laser.
●
The keys should be put into the lock (15) of your Galactic laser.
Warning
If the plug is not connected, your laser will not function.
If the key is not set to ON, your laser will not function.
