SHOWTEC 50426, Manual, Page: 8 / 14

6
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
One Sliding Profile Dimmer
1. Fasten the Sliding Profile Dimmer onto firm trussing . Leave at least 1 meter on all sides for air circulation.
2. Plug the cord into a proper electric power supply socket.
3. To setup the device, see page 8 for the menu settings.
Multiple Sliding Profile Dimmers
1. Fasten the Sliding Profile Dimmer onto firm trussing. Leave at least 1 meter on all sides for air circulation.
2. Use a 3-p or a 5-pin XLR cable to connect the Sliding Profile Dimmer s.
3. Link the units as shown in (Fig. 2), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug the cord into a proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Multiple Sliding Profile Dimmer Set Up
Fig. 2
Note : Link all cables before connecting electric power