10
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
1.
If the device does not operate properly, unplug the device.
2.
Check the fuse, power from the wall, all cables etc.
3.
If all of the above appears to be O.K., plug the unit in again.
4.
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5.
Return the device to your Showtec dealer.
No Power
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the Sliding Profile Dimmer does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the power supply, the fuse.
1.
Power supply. Check that the unit is plugged into an appropriate power supply.
2.
The fuse. Replace the fuse. See page 8 for replacing the fuse.
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction.
1.
Check the DMX setting. Make sure that DMX addresses are correct.
2.
Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
3.
Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
Summary of Contents for 50426
Page 1: ...2 Channel Sliding Profile Dimmer ORDERCODE 50426...
Page 14: ......