9
Order code: 44510
Pixel Controller
Installation
Remove all packing materials from the Pixel Controller. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Connect the device to the main power supply.
Multiple Fixtures Power Linking
The Pixel Controller supports power linking. Power can be relayed to another device via the power OUT
connector. Note that the input and the output connectors have different designs: one type cannot be
connected to the other.
To link fixtures in a chain, a hard usage cable with appropriate cable jacket must be used. Power linking
cables are available for purchase from Highlite International.
To prevent power overload and damage to the fixture, do not link more fixtures in one chain than
recommended. After you have reached the maximum number of fixtures, use a new power outlet.
Maximum recommended number of fixtures on a power link @ 110 V: 5 fixtures
Maximum recommended number of fixtures on a power link @ 240 V: 10 fixtures
Control Modes
There are 6 modes:
●
Auto
●
Manual
●
Master/Slave
●
DMX-512 (8CH, 480CH)
●
Art-Net (8CH, 480CH, 1920CH)
●
Kling-Net (40 pix/1 m, 80 pix/2 m, 120 pix/3 m, 160 pix/4 m)
One Pixel Controller (Auto, Manual)
01)
Fasten the controller to a firm trussing or place it on a flat surface. Leave at least 0,5 meter on all
sides for air circulation.
02)
Always use a safety cable (order code 70140 / 70141).
03)
Connect the Pixelstrips.
04)
Plug the end of the electric mains power cord into a proper electric power supply socket.
05)
When the controller is not connected by means of a DMX cable, it functions as a stand-alone
device.
06)
Please see page 23 for more information about Auto and Manual modes.
