Ordercode: 43539
Spectral ZP-5
Backside
Fig. 02
04)
3-pin DMX signal cable IN
05)
3-pin DMX signal cable OUT
06)
4-digit LED d menu buttons
07)
PowerCON True power connector 100-240V OUT
08)
PowerCON True power connector 100-240V IN
Installation
Remove all packing materials from the Spectral ZP-5. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
9
