SHOWTEC 41394, Manual

Page: 10 / 44

9
Ordercode: 41394
Expression 550S
Backside
Fig. 02
03)
Fuse T2,5AL/250V
04) PowerCON power connector 100-240V IN
05) PowerCON power connector 100-240V OUT
06) 5-pin DMX signal connector IN
07) 3-pin DMX signal connector IN
08) 3-pin DMX signal connector OUT
09) 5-pin DMX signal connector OUT
Installation
Remove all packing materials from the Expression 550S. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.