SHOWTEC 41370 Micro Spot, Manual

Page: 17 / 22

15
Static gobo-wheel
This static gobo-wheel has 9 gobos and open.
Shutter/Dimmer/Strobe
The dimming (0-100%) is provided by a simple mechanical shutter unit. This unit may also be used for strobe
effect (1-10 flashes per second).
Stand-alone Mode
The fixtures on a data-link are not connected to the controller, but can execute pre-set programs, which
can be different for every fixture.
To set the program to be played, see the page 13. Stand-alone operation” can be applied to a single
fixture (the fixture may be set to the master/slave mode or controller mode) or to multiple fixture operating
synchronously.
For synchronous operation of multiple fixtures the fixtures must all be connected on a data-link and one of
them is set as a master (master mode) and the rest as slaves (slave mode). The DMX address of all the
slaves are assigned to
and on that particular slave address only one fixture can be connected. To the
fixture as the master or slave, see “Addressing” (menu ).
If the master fixture resets or runs a test (program), all slaves will execute these acts too.
You can’t play or edit any program on a slave, if the master is switched on and connected to the
master/slave chain.
Note: Disconnect the fixtures from the DMX controller before master/slave operating, otherwise data
collisions can occur and the fixtures will not work properly!
It’s necessary to insert the XLR termination plug (with 120 Ohm ) into the input of the master fixture and into
the output of the last slave fixture in the data-link, in order to ensure proper transmission on the data link.
From the master’s control panel it is possible to control any slave in a master/slave chain.
Channels settings
Mode 13 Channels Mode 5 Channels
1. Pan 1. Pan
2. Pan Fine 16 bit 2. Pan Fine 16 bit
3. Tilt 3. Shutter
4. Tilt fine 16 bit 4. Colours
5. Pan/Tilt Speed 5. Static Gobos
6. Shutter
7. Red
8. Green
9. Blue
10. Colours
11. LED Speed
12. Auto Program
13. Static Gobos