Ordercode: 40466
Visiondrape DJ Curtain Set
Control Modes
There are 5 modes:
•
Built-in programs
•
Manual Mode (RGB)
•
Sound-controlled
•
Master/Slave
•
DMX-512 (8CH)
One Visiondrape (Built-in programs and Full Mode)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Visiondrape is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 and 15 for more information about the Built-in programs and Manual Mode.
One Visiondrape (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
Turn on the music. If the device is set to sound-control, then the Visiondrape will react to the beat of
the music. Please see page 15 for more information about the sound-control options.
Multiple Visiondrapes (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin XLR cable to connect the Visiondrape.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 14-15 (Built-in
programs, Manual Mode or Sound-controlled Mode). This means that you can set your desired
operation mode on the master device and all slave devices will react the same as the master
device. However, the DMX address of the slave devices must be the same as the one of the master
device.
Multiple Visiondrapes (Master/Slave control)
Fig. 03
10
