Ordercode: 40466
Visiondrape DJ Curtain Set
Controller
Fig. 02
01)
IEC power connector 100-240V IN + Fuse F2AL/250V
02)
Power switch ON/OFF
03)
3-pin DMX signal connector IN
04)
3-pin DMX signal connector OUT
05)
Speakon 1,2 m x 2 m curtain connector IN
Do not connect any IEC to Schuko-Speakon cables
06)
Speakon 2 m x 3 m curtain connector IN
Do not connect any IEC to Schuko-Speakon cables
07)
Ground/earth connection
08)
LCD d menu buttons
09)
Air intake grill
Installation
Remove all packing materials from the Visiondrape DJ Curtain Set. Check if all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
9
