9
Ordercode: 40292
Ignitor-6 Section Strobe
Control Modes
There are 4 modes:
•
Built-in programs
•
Sound-controlled
•
Master/Slave
•
DMX-512 (3 or 8CH)
One Ignitor-6 Section Strobe (Built-in Programs)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket
.
04)
When the Ignitor-6 Section Strobe is not connected by a DMX-cable, it functions as a stand-alone
device. Please see page 12 for more information about the built-in programs.
One Ignitor-6 Section Strobe (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Ignitor-6 Section Strobe is not connected by a DMX-cable, it functions as a stand-alone
device.
05)
Turn on the music.
If the device is set to
, then the Ignitor-6 Section Strobe will react to the beat of the music.
Please see page 12 for more information about the sound-control options.
Multiple Ignitor-6 Section Strobes (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-pin XLR cable to connect the
Ignitor-6 Section Strobe
.
The pins:
01) Earth
02) Signal -
03) Signal +
05)
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You
can use the same functions on the master device as described on page 12 (Brightness, Built-in
Programs or
Music control Mode). This means on the master device you can set your desired
operation Mode and all slave devices will react the same as the master device
.
Multiple Ignitor-6 Section Strobes (Master/Slave control)
Fig. 03
