9
Multiple LED Followspots (DMX Control)
1.
Fasten the effect light onto the stand. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket
.
3.
Use a 3-p XLR cable to connect the
LED Followspot
and other devices.
4.
Link the units as shown in (figure 3), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Multiple LED Followspots DMX Set Up
Fig. 3
Note : Link all cables before connecting electric power
Summary of Contents for 30628
Page 18: ......
