ShowPro PLUTO 800, User Manual

Page: 20 / 22

4
19
2700k
magenta magenta
2700k
blue blue
2700k
cyan cyan
2700k
green green
2700k
yellow yellow
2700k
orange orange
2700k
red red
5600k
red red
5600k
orange orange
5600k
yellow yellow
5600k
green green
5600k
cyan cyan
5600k
blue blue
5600k
magenta magenta
5600k
red red
2700k
red red
STATIC 1 STATIC 2 STATIC 3 STATIC 4
STATIC 5 STATIC 6 STATIC ALL RING1
RING2 RED-2700K ORANGE-2700K YELLOW-2700K
GREEN-2700K CYAN-2700K BLUE-2700K MAGENTA-2700K
RED-2700k RED-5600K ORANGE-5600K YELLOW-5600K
GREEN-5600K CYAN-5600K BLUE-5600K MAGENTA-5600K RED-5600K
2.2 FUSE REPLACEMENT
SAFTY CAP
FUSE
●
Remove the safety cap by a screwdriver.
etch the old fuse from safety cap.
●
F
nstall a new fuse.
●
I
nstall the safety cap.
●
I
●
220~240V: 14 units may be connected in series
●
110~120V: 7 units may be connected in series
2.3 POWER CONNECTIONS
Note:
If the signal cable is over 60m between the DMX512 controller and fixture
or beween two fixtures, then a DMX signal amplifier is needed as well.
1
3
2
2.4 Connect main controller with several fixtures
Termination plug
3pin XLR (male)
As image , terminate the link by installing a 120 Ohm
resistor in the output socket of the last fixture.
When connect main controller with several fixtures , please
Terminate the link by installing a termination plug in the output socket of the last fixture.
The termination plug, which is a male XLR plug with a 120 Ohm, 0.25 Watt resistor
soldered between pins 2 and 3, soaks up the control signal so it does not reflect and
cause interference.
Pixel effect function
After reset , the fixture head direction is the position of 1-3 LED chips