3
Ordercode: 950300
VIBE FX Polar Beat
Please consider that damages caused by manual modifications to the device are not subject to
warranty.
This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
●
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
●
Never remove warning or informative labels from the unit.
●
Never use anything to cover the ground contact.
●
Never lift the fixture holding it by the projector-head, as the mechanics may be damaged. Always
hold the fixture by the transport handles.
●
Never place any material over the lens.
●
Never look directly into the light source.
●
Never leave any cables lying around.
●
Never aim the laser beam at people or animals!
●
Never use the device during thunderstorms, unplug the device immediately.
●
Never point a laser at aircraft, this is a federal offense.
●
Never point unterminated laser beams into the sky.
●
Never open the laser housing. The high laser power levels inside of the protective housing can start
fires, burn skin and will cause instant eye injury.
●
Do not connect this device to a dimmer pack.
●
Do not open the device and do not modify the device.
●
Do not point lasers at highly reflective surfaces such as windows, mirrors and shiny metal. Even laser
reflections can be hazardous.
●
Do not expose the output optic (aperture) to cleaning chemicals.
●
Do not use laser if the laser appears to be emitting only one or two beams.
●
Do not use laser if housing is damaged or open, or if optics appear damaged in any way.
●
Do not operate laser without first reading and understanding all safety and technical data in this
manual. Never look into the laser aperture or laser beams.
●
Do not switch the device on and off in short intervals, as this will reduce the device’s life.
●
Do not touch the device’s housing bare-handed during its operation (housing becomes very hot).
Allow the fixture to cool for at least 5 minutes before handling.
●
Do not shake the device. Avoid brute force when installing or operating the device.
●
After set up and prior to public use, test laser to ensure proper function. Do not use the laser if any
defect is detected. Do not use, if the laser emits only one or two laser beams rather than
dozens/hundreds, as this could indicate damage to the diffraction grating optic, and could allow
emission of higher laser levels.
●
Only use the device indoors, avoid contact with water or other liquids.
●
Only operate the fixture after having checked if the housing is firmly closed and all screws are tightly
fastened.
●
Only operate the device after having familiarized with its functions.
●
Avoid flames and do not put close to flammable liquids or gases.
●
Always check the regulations when using a class 2 laser product.
●
Always check and position the laser before anybody enters the room, when the laser is facing an
area with people.
●
Always keep the case closed while operating.
●
Always allow a free air space of at least 50 cm around the unit for ventilation.
●
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power cord holding it by the plug. Never pull out the plug by tugging the power cord.
●
Make sure that the device is not exposed to extreme heat, moisture or dust.
●
Make sure that the available voltage is not higher than stated on the rear panel.
●
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
●
If the external cable is damaged, it has to be replaced by a qualified technician.
Summary of Contents for VIBE FX Polar Beat
Page 16: ...2017 Showgear...
