9
Ordercode: 950105
VIBE FX Image Spot
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Power ON/OFF
01)
Move the switch (06) to the left/right, to activate the desired control mode.
02)
Move the switch (06) to the center, to switch the Image Spot off.
Control Modes
1. Manual Mode
01)
Move the switch (06) to the right, to activate Manual mode.
02)
Turn the control (05) to the left/right to decrease/increase the gobo rotation speed.
2. Timer Mode
01)
Move the switch (06) to the left, to activate Timer mode.
02)
Turn the control (05) to the left/right to decrease/increase the gobo rotation speed.
03)
The device will now run for 6 hours and then it will automatically turn off.
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04)
The electric power supply cables must not show any damages or material fatigue.
The VIBE FX Image Spot requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents.
The front lens will require weekly cleaning, as smoke-fluid tends to build up residues, reducing the light
output very quickly.
Please clean internal components once a year with a light brush and vacuum cleaner.
