Showgear 950200, Manual

Page: 14 / 16

13
Ordercode: 950200
VIBE FX Strike
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect two potential problem areas as: the power supply and the laser.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02) The laser. Return the Strike to your Showgear dealer.
03) If all of the above appears to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not open the Strike, as this may
damage the unit and the warranty will become void.
05) Return the device to your Showgear dealer.
Problem
Probable cause(s) Remedy
The fixture does
not function at all
No power to the fixture.  Check if power is switched on.
Internal fuse blown.
 Disconnect fixture and return to your
dealer.
No light or laser
cuts out
intermittently
Fixture is too hot.
 Allow fixture to cool.
 Make sure the air vents are not
blocked.
 Turn up the air conditioning .
Laser damaged
 Disconnect fixture and return to your
dealer.
The power supply settings do not
match local voltage and
frequency.
 Disconnect fixture. Check settings and
correct if necessary.