19
RainDome 40 cm
Product code: 71325
Operation
When the device is connected to power supply, the device is in operation. The fan starts rotating and the
installed plastic sleeve becomes inflated.
●
To turn the device on, connect the device to power supply. See 5.6. Connecting to Power Supply on
page 18 for more information.
●
To turn the device off, disconnect the device from power supply.
Using the Bypass Function
The device has a built-in pressure sensor. If the pressure decreases in the inflated plastic sleeve during
operation, the sensor disconnects the 3 power output connectors: pro power connector OUT (01), pro
power True1 connector OUT (02) and Schuko power connector OUT (03). The stage luminaire powered by
one of those connectors turns off.
To adjust the settings of the connected stage luminaire, you can use the bypass switch (12). The bypass
switch (12) temporarily deactivates the built-in air pressure sensor.
Attention
Risk of damage to property
If the stage luminaire has a moving head, the plastic sleeve and the stage luminaire may become
damaged if the stage luminaire moves when the plastic sleeve is not fully inflated.
Make sure that the stage luminaire is not moving while you are adjusting its settings. If the plastic sleeve is
not fully inflated it can be caught by the moving head of the stage luminaire.
To use the bypass function, follow the steps below:
Press and hold down the bypass switch (12).
Adjust the settings on the stage luminaire through the plastic sleeve. Do not remove the plastic
sleeve.
Wait until the plastic sleeve is fully inflated again.
Release the bypass switch (12).
Summary of Contents for 71325
Page 24: ... 2022 Showgear ...
