9
Ordercode: 41268
Pixel Bar 4 COB
Control Modes
There are 6 modes:
Stand-alone (Manual Color control, Built-in Programs, Auto run)
Sound-controlled
Master/Slave
DMX512 (2CH, 3CH, 5CH, 6CH, 12CH)
One Pixel Bar (Manual Control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Pixel Bar is not connected with a DMX cable, it functions as a stand-alone device.
05)
Please see page 14 for more information about the manual control functions.
One Pixel Bar (Built-in Programs, Auto run)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Pixel Bar is not connected with a DMX cable, it functions as a stand-alone device.
05)
Please see page 15 for more information about the Built-in programs or the Auto Run functions.
One Pixel Bar (Sound-controlled)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Pixel Bar is not connected with a DMX cable, it functions as a stand-alone device.
05)
Turn on the music. If the device is set to SU00, then the Pixel Bar will react to the beat of the music.
Please see page 15 for more information about the sound-control options
Multiple Pixel Bars (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-pin XLR cable to connect the Pixel Bar.
The
pins:
1.
Earth
2.
Signal (-)
3.
Signal (+)
05)
Link the units as shown in (Fig. 03), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 14-15 (Manual Control or Sound
control). This means that you can set your desired operation mode on your master device and all
slave devices will react the same as the master device.
Multiple Pixel Bars (
Master/Slave control)
Fig. 03
