Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorestation.com
0003277
Page 13
SS1204
Control Arm Assembly
Locate the pendant control assembly. Insert the connector end of
the wire into the end of the control arm without holes drilled through
it. Push the wire into the control arm tube until the plug comes out
of the other end of the control arm tube. Pull the bulk of the wire
through the control arm tube for now.
Attach the control arm tube to the control arm pivot weldment by
aligning the holes in both parts. Insert a ¼” x 6” hex bolt into the
hole in the end of the control arm, then through the hole in the con-
trol arm pivot weldment. Place on the compression spring followed
by a 3/8” flat washer, ¼” flat washer and a ¼” hex nut. Tighten until
the spring is slightly compressed. This can be changed to achieve
the desired tension once it is being used. Place a ¼” x 2 ¼” hex
bolt into the second hole in the control arm tube and the control arm
pivot weldment. Secure using a ¼” hex nut. Tighten.
Insert the 72” extension leg into Post No. 4 that is next to the hy-
draulic pump. Secure it in Post No. 4 using a ½” x 4” hex bolt and
flange lock nut. Place another ½” x 4” hex bolt through the hole
provided in the 72” extension leg approximately 14” from the end of
the extension leg. Slide the control arm tube assembly assembled
earlier over the top of the extension leg. Lower until it is resting on
the ½” x 4” hex bolt installed earlier. Once it is resting on the bolt
place a third ½” x 4” hex bolt in the top hole of the extension leg to
keep it from coming off. Tighten.
