13
STEP 2:
Simultaneously (both sides) lift the top panel to clear the panels while pushing the
side panels at the middle seam to clear the top panel pin. See FIGURE 2.6
STEP 3:
Raise the top panel high enough to clear
the front and side panels until they are
fully collapsed while sliding the front panel
towards the back panel. Hand placement is
important while folding the wall panels.
Right hand side:
Left hand on top panel
handle, right hand on wall panel handle.
(Left hand side shown)
Left hand side:
Right hand on top panel
handle, left hand on wall panel handle.
(Left hand side shown)
NOTE:
Apply inward pressure to the side panels to encourage simultaneous
folding of the side panels.
STEP 4:
Rotate and slide the retaining pin into the
pin receiver and lower the front casters.
Repeat for both the right and left sides. See
FIGURE 2.7
STEP 5:
Slowly lower the top panel down-over the
front panel.
Keep hands clear of possible pinch areas
when moving parts which, if not avoided,
could result in MINOR to MODERATE INJURY.
Shelf Operation
During movement and storage, the shelves should be in the stowed position,
upright. The shelves pivot on their wall brackets. Rotate the shelf upward for the
stowed position.
The shelves must be in the upright, stowed position when collapsing the unit.
Collapsing the unit with the shelves in the down position WILL damage the unit.
Caster Operation
The front panel casters should be operated
simultaneously and the back panel casters should be
operated simultaneously. Hold the unit when raising
or lowering the casters, a slight lift of the unit lessons
the load while depressing or releasing the caster foot
operated pedal. See FIGURE 2.8
Keep the area clear of personnel and animals
when raising and lowering the unit. Maintain full
control of the unit when operating the caster
foot operated pedal, which if not avoided, could
result in MINOR to MODERATE INJURY.
When the Kat Klowder is left unattended and in the collapsed position, always
disengage the casters to prevent the unit from unintentional movement.
FIGURE 2.6 - Unfolding The Panels
SLIDE-IN THE
DOOR PANEL
LIFT TOP PANEL TO
CLEAR DOOR PANEL
FIGURE 2.7 - Retaining Pin
FIGURE 2.8 - Caster Foot Pedal
UP TO
DISENGAGE
CASTERS
DOWN TO ENGAGE
CASTERS
SECTION TWO
