~10~
JOYSTICK CONVERSION (right to left or left to right)
Loosen the hand knob [Fig.2 (3)] and remove the entire armrest assembly with the
joystick attached. Place the armrest assembly on the desired side. Reset in position
by re-tightening the hand knobs to complete joystick conversion.
SEAT HEIGHT ADJUSTMENTS (Fig.4)
Disconnect the power cord coming from the joystick/controller at the back of the
Powerchair by pressing on the latch with your left hand and firmly pulling the cable
plug with your right hand. Remove the seat by releasing the tightening lever. The seat
supporting post under the seat has two height adjustment holes. The height of the
seat can be adjusted by tightening the Hex Head Bolt and Nyloc Nut in any one of the
two holes. This also secures the seat supporting post to the power base. Make sure
that all connections are tightened before operating the Powerchair.
ADJUSTMENT PROCEDURES
Fig. 4
Hex Head Bolt
Tightening Lever
Seat Supporting Post
Nyloc Nut
Summary of Contents for UL8-W12 COMO
Page 24: ...24...