To pick up dust and dry material, you must install foam sleeve and reusable
dry filter or disposable filter bag to ensure proper filtration. If the vacuum
has been used to pick up liquids, the foam sleeve must be cleaned and
dried before installing for dry pick up. With tank cover in an upside down
position, slide foam sleeve down over lid cage pulling until foam sleeve
completely covers lid cage
(Figure 1, 2)
. Center the reusable dry filter
(not
standard on all models)
on lid cage
(Figure 3)
, slide mounting ring down
over filter until ring is positioned against the ribs of the lid cage
(Figure 4)
.
The reusable dry filter should always be in position over the foam sleeve
for dry pick up. To remove the filter for cleaning, remove mounting ring and
filter from lid cage
(Figure 5)
. To clean the reusable dry filter, shake off
excess dirt and dust or (depending on the condition of the filter) rinse with
water. Allow the filter to dry completely and reinstall.
NOTE: ENSURE THAT THE MOUNTING RING IS COMPLETELY SECURE AND IN POSITION BY PRESSING DOWN FIRMLY AROUND THE RING IN
SEVERAL PLACES. BE SURE THE REUSABLE DRY DISC FILTER COMPLETELY COVERS THE FOAM SLEEVE. CHECK TO ENSURE THAT ALL EDGES OF
THE REUSABLE DRY FILTER ARE SECURE UNDER THE MOUNTING RING.
CAUTION -
KEEP FILTER CLEAN.
Efficiency of the vacuum is largely dependent on the filters. Dirty filters will reduce the air flow and efficiency of the filtration system.
DO NOT MACHINE WASH OR DRY.
DOUBLE INSULATION
Do not operate if cord, plug or appliance is damaged. In your double insulated appliance, two systems of insulation are provided instead of
grounding. No grounding means is provided nor should a means for grounding be added to the appliance.
NOTE:
If power cord needs to be replaced, use only a Shop-Vac Service Agent.
EXTENSION CORDS
NOTE:
STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE RELATIVE HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY AND
DOES NOT AFFECT THE USE OF THE APPLIANCE. TO REDUCE THE FREQUENCY OF STATIC SHOCKS IN YOUR HOME, THE BEST REMEDY
IS TO ADD MOISTURE TO THE AIR WITH A CONSOLE OR INSTALLED HUMIDIFIER.
Use only a cord extension set that complies with AS3199. Conductor size must be 1.0mm
2
for length up to 25 metres and 1.5mm
2
for length
from 25 - 32 metres.
UNPACKING AND SET-UP
Remove tank cover and any accessories which may have been
shipped in the tank.
Before replacing tank cover, please refer to DRY PICK UP or WET
PICK UP OPERATION in this manual to ensure you have the proper
filters installed for your cleaning operation.
Replace tank cover.
Slip cleaner end of flexible hose into the intake port.
1.
2.
3.
4.
Attach the extension wands to the accessory end of the hose.
Twist slightly to tighten the connection.
Attach one of the cleaning accessories (depending on your
cleaning requirements) to the extension wand. Twist slightly to
tighten the connection
Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON O = OFF
5.
6.
7.
DRY PICK UP OPERATION
WARNING -
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING THE
TANK COVER.
1
2
3
4
5
LIMITED TWO-YEAR WARRANTY
Shop-Vac warrants the vacuum cleaner for two years from the date of purchase to correct by repair or parts replacement without charge, any
product defect due to faulty material or workmanship provided that the vacuum cleaner is not used for rental service. This warranty does not
cover accessories. Simply return the complete unit, (transportation prepaid), to the Authorized Shop-Vac Service Centre nearest you (a complete
list of Authorized Shop-Vac Service Centres is included with each vacuum cleaner). Shop-Vac assumes no responsibility for damage or faulty
performance caused by misuse or careless handling, or where repairs have been made or attempted by others. Proof of purchase date is
required. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Our goods come with
guarantees that cannot be excluded under the Australian Consumer Law.You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage.You are also entitled to have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not amount to a major failure.
INSTALLING THE FOAM SLEEVE AND DRY FILTER DISC
•
NOT STANDARD ON ALL MODELS
