TROUBLE
POSSIBLE CAUSE
REMEDY
TROUBLESHOOTING
WARNING -
IF ANY OF THE MOTOR HOUSING PARTS SHOULD BECOME DETACHED OR BROKEN,
EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL COMPONENTS, OPERATION SHOULD BE
DISCONTINUED IMMEDIATELY TO AVOID PERSONAL INJURY OR FURTHER DAMAGE TO THE VACUUM.
REPAIRS SHOULD BE MADE BEFORE REUSING THE VACUUM.
Suction weakens or
cleaner runs hot.
Clogged filter
Brush dirt from filter. If condition continues, change filter.
Air leak
Check all fittings for tight fit (nozzles, hoses, etc.).
Check that tank cover is sealed properly.
Obstruction in
hose or nozzle
Check nozzle, hose, etc. for obstructions, and remove if present.
Misting in the exhaust air.
Saturated filter
Replace saturated filter with a dry filter.
87552-56
STORAGE
Before storing your vacuum cleaner, the tank should be emptied and cleaned. The power cord can be wound around the housing of the unit for
convenience. Accessories may be stored in the caster dolly tool holder on rear of unit.
The cleaner should be stored indoors
.
230 -240 Volt
Voltage
50-60Hz
Max Wattage
from Motor
Max Wattage
from Receptacle
1400
1000
FOR UNITS WITH BUILT - IN RECEPTACLE
This vacuum cleaner is equipped with a built-in electrical socket which allows a power tool (circular saw, drill, sanding machine, etc...) to be
plugged directly into the cover assembly, and an automatic tool triggering feature for a clean work environment.
!WARNING! Do not plug any tool or appliance rated over the
maximum wattage for the receptacle as noted in the
chart
above into the electrical socket on the vacuum cleaner. Check nameplate of the tool for the wattage rating. To
reduce the risk of injury, tool must be turned (O) OFF before
placing switch in the (=) AUTO position. (NEVER LEAVE
THE UNIT RUNNING OR PLUGGED IN UNATTENDED).
The power switch is used to select the automatic tool triggering feature built into the vac. With the (–) ON position selected, the vac will simply run
continuously. When the (=) AUTO position is selected, the vac will automatically turn on and off when the power tool is turned on and off.
For the auto tool triggering feature to work, the power tool must draw a minimum of 60 Watts. The maximum wattage rating for the electrical
socket is rated in the chart above. Lift cover upward on the receptacle to access the socket. If the plug you are inserting does not match the socket
construction, do not attempt any modifications as this could cause a hazard and will void any warranty.
REPAIR OR REPLACEMENT OF PARTS
Never attempt any service to the unit unless the power cord is disconnected from the power receptacle.
These units incorporate electrical components that can be replaced. It is recommended that repair or part replacement be performed by a skilled
technician. Only use original manufacturer recommended replacement parts. If the receptacle cover becomes detached, broken or damaged, or clear
boot over switch would be damaged or missing, discontinue operation and have the unit repaired.
