Shop-Vac 5892210, User Manual

Page: 5 / 34

PAGE 5
ASSEMBLY
MOUNTING WALL BRACKET
1. Select mounting location at a wall stud and/or provide a surface which is strong enough to hold the com-
bined weight of the vacuum with a full tank of debris and accessories.
WARNING
– INADEQUATE MOUNTING COULD ALLOW THE UNIT TO FALL,
CAUSING INJURY AND/OR DAMAGE TO THE UNIT.
2. Secure wall bracket to mounting surface with 2 screws provided or other suitable
fastener. (
NOTE:
The screws provided are adequate ONLY for mounting into wood.
Be sure to use the proper, suitable fasteners for mounting vacuum to a surface other
than wood.) Be sure wall bracket is level.
3. Install vacuum by aligning groove on either side of tank to engage as the vacuum
is lowered onto the wall bracket.
4. To avoid possible injury or damage by dislodging vacuum from wall bracket or dropping tank during unlatch-
ing, always remove the entire vacuum from wall bracket and set on floor to empty tank or service filter.
5. Before removing vacuum from wall bracket, check to make sure tank cover is
secured to tank. To remove vacuum from wall bracket, grasp top handle with one
hand and tank bottom with other hand. Slide vacuum off of wall bracket by lifting
straight up on vacuum.
SET UP AND OPERATION
DANGER
–
This equipment incorporates parts such as switches, motors or the
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct
filters are installed for your cleaning operation.
2. Replace tank cover on the tank by aligning tabs with the lugs. Press down firmly
on the upper housing until tank cover snaps into place.
3. Install machine hose end into inlet located on the front of the tank.
4. Attach the desired cleaning accessory onto the accessory end of the hose.
NOTE:
Many more useful tools are available at your local dealer or the Shop-Vac
®
website.
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF