Shop-Vac 5801611, User Manual

Page: 6 / 36

15. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
GENERAL SET UP
PAGE 5
16. Replace the tank cover.
Lift latches up and place in
the grooves on the cover as
shown in FIGURE 15 . Push
in on bottom of latches to
lock in place.
FIGURE 15
ASSEMBLY
FIGURE 3
FIGURE 4
You will find four casters
FIGURE 3
, accessory
caddy
FIGURE 4 ,
two
caster feet
FIGURE
5 ,
four screws and four
washers with your wet/
dry vacuum. Assemble as
follows:
CASTER SYSTEM
ASSEMBLY
4. With cord disconnected from the receptacle and tank
cover removed, turn tank upside-down so bottom is
facing up.
FIGURE 6
5. Take accessory caddy
and place into slots located
on rear of tank (opposite of
drain). Secure with screws
provided. FIGURE 6.
FIGURE 5
FIGURE 7
6. Take two casters and
place a flat washer over the
stem of each caster. Install
casters into accessory caddy
by inserting the caster stems
into the holes provided. Apply
pressure and twisting motion
until the casters snap into
place. FIGURE 7.
FIGURE 8
7. With tank drain facing
you, take caster foot marked
with the letter A and place
into slot on left side of tank,
also marked with the letter
A . FIGURE 8.
A
A
A
B
8. Secure caster foot to
tank with screw provided.
FIGURE 9.
FIGURE 9
FIGURE 10
B
9. Take caster foot marked
with the letter
B
and place
into slot on right side of tank,
also marked with the letter
B
.
FIGURE 10.
10. Secure caster foot to
tank with screw provided.
FIGURE 11.
FIGURE 11
11. Take the remaining
casters and place a flat
washer over the stem of
each caster. Insert casters
into caster feet by placing
the caster stems into the
holes provided. Apply
pressure and twisting motion
until casters snap into place.
FIGURE 12.
FIGURE 12
14. Return tank to upright position.
12. With tank drain facing
you, attach hose holder A
to caster foot A, and hose
holder B to caster foot B.
FIGURE 13.
FIGURE 13
13. Apply pressure to front
of hose holder to snap into
place. FIGURE 14.
FIGURE 14