-16-
Model W1873/W1874 (For Machines Mfd. Since 10/20)
SE
TU
P
Inventory
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note:
If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Box.1.(Figure.4).
Qty
A.
Planer Unit (Not Shown)..................................1
B.
Cast-Iron Extension Tables ...............................2
C..
Dust Port ....................................................1
D.
Headstock Elevation Handwheel ........................1
Tools.and.Hardware.(Figure.5)
E.
Hex Bolts M8-1.25 x 25 (Ext. Tables) ...................6
F.
Button Head Cap Screws M6-1 x 12 .....................6
G.
Set Screws M8-1.25 x 20 (Ext. Tables) .................6
H.
Hex Wrench 4mm ..........................................1
I.
LOW/HIGH Direction Label (Handwheel) ...............1
J.
Hex Nut M10-1.25 (Handwheel) .........................1
K.
Flat Washer 10mm (Handwheel) ........................1
L.
Key 4 x 4 x 10 (Handwheel)..............................1
M.
Handwheel Handle (Handwheel) ........................1
N.
Wrenches 10/13, 12/14, 17/19mm ................1 Ea.
O.
T-Handle Torx Drivers T-25 ...............................2
P.
T-Handle Torx Driver T-30 ................................1
W1874.Only.(Figure.7)
R.
Flat Head Torx Screws #10-32 x
1
⁄
2
" .................. 10
S.
Indexable Carbide Inserts 15 x 15 x 2.5 ...............5
W1873.Only.(Figure.6)
Q.
Knife-Setting Jig ...........................................1
—E-clips 9mm ..............................................4
—Jig Feet ...................................................2
—Jig Shaft...................................................1
Figure.4.
Box inventory.
B
C
D
Figure.7.
Tools and hardware (W1874 only).
S
R
Figure.5.
Tools and hardware.
LOW
HIGH
E
G
N
H
J
K
L
M
F
I
O
P
Figure.6.
Tools and hardware (W1873 only).
Q
