-16-
Model W1767 (For Machines Mfd. Since 08/15)
SE
TU
P
Once power feeder assembly is complete and mounted on
the table, you must test run your power feeder to make
sure it runs properly. Your power feeder motor has two
feed speeds and two feed directions that are controlled at
the switch (see
Figure.10
).
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the power
feeder immediately, then review the
Troubleshooting
table on
Page.23
.
If you still cannot remedy a problem, contact our
Technical Support at (360) 734-3482 for assistance.
To.test.run.the.power.feeder,.do.these.steps:
1.
Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
power feeder is adjusted and is setup properly.
2.
Make sure that the power feeder gearbox oil level is
full. The oil level should be 1" below the oil fill port.
.
.
Note:
See
Figure 14
on
Page 21
for oil fill port
location.
3.
Ensure that all tools and objects used during set up
are cleared away from the machine.
4.
Adjust and lock the power feeder so the wheels are
held approximately one inch above the table and
nothing will interfere with wheel rotation.
5.
Connect the power feeder to the power supply and
use the feed direction and speed switch (see
Figure.
10
) to test operation in both feed directions.
— Listen and watch for abnormal noises or
vibrations. The power feeder should run smoothly.
— Correct for any unusual noises or vibrations before
operating the power feeder any further. Always
disconnect the power feeder from power when
investigating or correcting potential problems.
6.
Turn the feed direction switch to
OFF
.
Test.Run
Projectiles. thrown. from. the. machine.
could. cause. serious. eye. injury.. Wear.
safety. glasses. to. reduce. the. risk. of.
injury.
Loose. hair. and. clothing. could. get.
caught.in.machinery.and.cause.serious.
personal. injury.. Keep. loose. clothing.
rolled. up. and. long. hair. tied. up. and.
away.from.machinery.
Figure.10.
Feed direction and speed
switch.
Summary of Contents for W1767
Page 33: ...30 Model W1767 For Machines Mfd Since 08 15 PARTS Notes...
Page 34: ...Model W1767 For Machines Mfg Since 5 07...
Page 37: ......
