-11-
Model W1727 (For Machines Mfg. Since 5/09)
SE
TU
P
Figure 10.
Base assembly.
Base & Supports
To assemble this dust collector, do these steps:
1. MAKE SURE THE DUST COLLECTOR MOTOR IS
UNPLUGGED!
2.
Install two swivel casters with the two
5
⁄
16
"-18 acorn
nuts and
5
⁄
16
" flat washers (see
Figure
10
).
3.
Install the two fixed casters with the four M6-1 x 10
cap screws (see
Figure
10
).
4.
Place the round and rectangle support mounting
flanges against the base, and install with six
5
⁄
16
"-18
x
1
⁄
2
" hex bolts (see
Figure
10
).
5.
With the help of an assistant, attach the impeller/
separator assembly to the supports with the remain-
ing six
5
⁄
16
"-18 x
1
⁄
2
" hex bolts (see
Figure
11
).
6.
Position the elbow as shown in
Figure
11,
and
secure it in place with the 10-24 x
3
⁄
8
" flange screw.
7.
Position the handle as shown in
Figure
11,
and
secure it in place with two
5
⁄
16
"-18 x 1" flat head
screws.
8.
Insert the ends of the bag support into the receivers
welded to the impeller/separator assembly until the
ends are completely seated (see
Figure
11
).
9.
Insert the bag clamps into the hemmed rim of each
dust collector bag.
10.
Install the dust filter bag on the top of the dust col-
lector bag housing (the
SHOP FOX
®
logo is printed
on it), and snap the bag clamp lever closed.
11.
Install the lower plastic dust collection bag, and
snap the bag clamp lever closed.
For quiet and vibration-free operation, assemble your
dust collector as outlined below. DO NOT modify this
dust collector for any other purpose than what it is
designed for.
Swivel
Caster
Round
and
Rectangle
Support
Mounting
Flanges
Figure 11.
Basic assembly.
Impeller/Separator
Assembly
Elbow
Handle
Receiver
Bag
Support
Fixed
Caster
