Shop fox W1692, Instruction Manual

Page: 18 / 48

16
2. Hold the chain away from the sprocket
while you turn the sprocket. Make sure, as
you adjust each sprocket, that you count
the number of teeth that pass a fixed
point.
3.
Moving the sprockets clockwise lowers the
table and moving them counter-clockwise
raises the table. Each tooth on the corner
sprockets equals 0.016" of vertical
movement when the sprockets are turned.
4.
After you have the table adjusted to within
0.016" from front-to-back and from side-to-
side, tighten the chain so all of the slack is
removed.
5. Loosen the table mounting screws and
lift/lower the table until the table and the
cutterhead body are parallel with each
other and the table is parallel with the
head casting from front to back.
NOTE: This adjustment may require some
trial and error. See
Figure 12 .
6. Adjust each column on both sides until the
table is properly set. While adjusting the
columns, tighten each screw after each
step to ensure accurate results.
7. If you have already adjusted the knives, go
to page 20 and adjust the feed rollers and
chip breaker.
ADJUSTMENTS