Shop fox W1692, Instruction Manual

Page: 12 / 48

10
Figure 4. Extension roller-to-table alignment.
Extension Rollers
The extension roller assemblies are identical for
both the infeed and the outfeed ends of the
table. Depending on the length of the
workpiece, to help minimize snipe, you may
have to adjust the extension rollers
periodically so they are approximately 0.030"
above the table.
To mount the extension rollers, do these
steps:
1. Loosen the setscrews where the table
rollers mount to the planer body (on both
ends) as shown in
Figure 3 .
2. Use a wrench to lower the rollers on their
eccentric shafts
3. Position the extension roller assemblies on
the planer table, and install the M8-1.25 x
20 mounting bolts and washers finger tight.
See Figure 3.
4.
Place a straightedge across the table and
across the rollers as shown in
Figure 4
.
5. Turn the adjustment setscrews (See Figure
5.) so the extension roller assemblies are
flush with the table surface as indicated by
the straightedge.
6.
Tighten the mounting bolts to secure the
extension bar in place. See
Figure 5.
The top of the rollers should now be
completely even with the top of the table.
Double-check to make sure that the rollers
did not move during the tightening process.
Do not adjust the table rollers you
previously retracted into the planer table,
because the final set of adjustments will be
explained in the ADJUSTMENTS section.
Figure 5. Installed roller extension.
Figure 3. Table rollers and setscrews.
Setscrew
Table
Roller
Adjustment
Setscrew
Mounting
Bolt
Eccentric
Extension
Bar
Table
Roller
ASSEMBLY